Adding swap in Flatcar Linux¶
Swap is the process of moving pages of memory to a designated part of the hard disk, freeing up space when needed. Swap can be used to alleviate problems with low-memory environments.
By default Flatcar Linux does not include a partition for swap, however one can configure their system to have swap, either by including a dedicated partition for it or creating a swapfile.
Managing swap with systemd¶
systemd provides a specialized
.swap unit file type which may be used to activate swap. The below example shows how to add a swapfile and activate it using systemd.
Creating a swapfile¶
The following commands, run as root, will make a 1GiB file suitable for use as swap.
mkdir -p /var/vm fallocate -l 1024m /var/vm/swapfile1 chmod 600 /var/vm/swapfile1 mkswap /var/vm/swapfile1
Creating the systemd unit file¶
The following systemd unit activates the swapfile we created. It should be written to
[Unit] Description=Turn on swap [Swap] What=/var/vm/swapfile1 [Install] WantedBy=multi-user.target
Enable the unit and start using swap¶
systemctl to enable the unit once created. The
swappiness value may be modified if desired.
$ systemctl enable --now var-vm-swapfile1.swap # Optionally $ echo 'vm.swappiness=10' | sudo tee /etc/sysctl.d/80-swappiness.conf $ systemctl restart systemd-sysctl
Swap has been enabled and will be started automatically on subsequent reboots. We can verify that the swap is activated by running
$ swapon NAME TYPE SIZE USED PRIO /var/vm/swapfile1 file 1024M 0B -1
Problems and Considerations¶
Btrfs and xfs¶
Swapfiles should not be created on btrfs or xfs volumes. For systems using btrfs or xfs, it is recommended to create a dedicated swap partition.
The swapfile cannot be larger than the partition on which it is stored.
Checking if a system can use a swapfile¶
df(1) command to verify that a partition has the right format and enough available space:
$ df -Th Filesystem Type Size Used Avail Use% Mounted on [...] /dev/sdXN ext4 2.0G 3.0M 1.8G 1% /var
The block device mounted at
/dev/sdXN, is the correct filesystem type and has enough space for a 1GiB swapfile.
Adding swap with a Container Linux Config¶
The following config sets up a 1GiB swapfile located at
storage: files: - path: /etc/sysctl.d/80-swappiness.conf filesystem: root contents: inline: "vm.swappiness=10" systemd: units: - name: var-vm-swapfile1.swap contents: | [Unit] Description=Turn on swap Requires=create-swapfile.service After=create-swapfile.service [Swap] What=/var/vm/swapfile1 [Install] WantedBy=multi-user.target - name: create-swapfile.service contents: | [Unit] Description=Create a swapfile RequiresMountsFor=/var ConditionPathExists=!/var/vm/swapfile1 [Service] Type=oneshot ExecStart=/usr/bin/mkdir -p /var/vm ExecStart=/usr/bin/fallocate -l 1024m /var/vm/swapfile1 ExecStart=/usr/bin/chmod 600 /var/vm/swapfile1 RemainAfterExit=true